You can change the title that will appear at the top of each sequence
by selecting the Change Title command. A popup
will appear, prompting you for a new title, or Sdtty will
ask you to type in the new title. This action will become
effective the next time a sequence is written out. Sequences previously
written will keep their old title. You can remove the title by just
pressing ENTER when asked for the new title.
When the program starts, there is no title unless the initialization file was used. See section The Initialization File.
When the initialization file is used, any change in the title will be written back to the init file at the end of the session.
Go to the first, previous, next, last section, table of contents.